ECUHELP KT200II ECU Programmer is tested to read/write ford Focus 1.6ti ecu continental ems2204 Boot mode, OBD mode no because no VR file on server.
KT200II wiring diagram of SIEMENS EMS2204 [ TC1738 INT.F.] – Ford:
Kit to use:
– Multifunction cable
– OBD cable (for search password via OBD)
– 1 resistance 560 Ω
PASSWORD SEARCH:
Connect the pinout below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Tool Password
→ OBD PASSWORD EMS2204 FORD
→ Click on “Find Password” and follow the software messages
Attention:
For these ECUs it may be necessary to find the password via OBD.
So, IF it is not found via pinout, re-run the driver on the car via OBD.
Now that the password has been found it’s possible to read and write the control unit. See the next step.
READ AND WRITE ECU:
Connect with the multifunction cable the following pinout and the boot shown on the next page.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1738
Connect the following pinout:
Solder a 560 Ω resistor to the bottom:
Connect the gray wire to the two points indicated:
