Step-by-step procedure on how to read and write VAG VW Audi Skoda Seat Bosch MED17.1.1 TC1796 /TC1797 Bench and Boot Mode ECUHELP KT200 ECU programmer.
1. Bench Mode
BOSCH MED17.1.1 [ 1796 ]
Connect the multifunction cable as follows:
KT200 read and write MED17.1.1 use the following driver:
→ BENCH TRICORE
→ VW / AUDI / SEAT / SKODA
→ TC1796 – VAG
→ MED17.1.1
BOSCH MED17.1.1 [ 1797 ]
Connect the multifunction cable as follows:
KT200 read and write BOSCH MED17.1.1 [ 1797 ] use the following driver:
→ BENCH TRICORE
→ VOLKSWAGEN / AUDI / SEAT / SKODA
→ TC1797 – VAG
→ MED17.1.1
Attention:
Some MED17.1.1 enter in Bench mode with the brown wire on Pin 18. If with the previous pinout doesn’t go in bench tricore mode, then try again by connecting it as follows:
2.Boot Mode
BOSCH MED17.1.1 [ TC1796 INT.F.]
Kit to use: – Multifunction cable
KT200 READ AND WRITE ECU
Connect with the multifunction cable the following pinout and the boot shown below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1796
ATTENTION:
If the password error message appears at the beginning of the reading, proceed as follows:
PASSWORD SEARCH
Disable the boot mode by unsoldering the gray wire. Connect the pinout below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Tool Password
→ OBD PASSWORD TPROT V08 VAG
→ Click on “Find Password” and follow the software messages.
Now that the password has been found it’s possible to read and write the control unit as described in STEP 1.
BOSCH MED17.1.1 [ TC1797 INT-.F.]
Kit to use:
– Multifunction cable
KT200 READ AND WRITE ECU
Connect with the multifunction cable the following pinout and the boot shown below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1797
ATTENTION:
If the password error message appears at the beginning of the reading, proceed as follows:
PASSWORD SEARCH
Connect the pinout below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Tool Password
→ PASSWORD BFT
→ Click on “Find Password” and follow the software messages.
If the password was found with this system, go directly to the boot step to read and write the control unit.
Otherwise, move the violet wire on pin 18 and restart the driver PASSWORD BFT:
Now that the password has been found it’s possible to read and write the control unit as described in STEP 1.