ECUHELP KT200 R/W fiat 500x 1.0 120cv 2019 ecu Continental?
KT200 can read and write GPEC3 and GPEC4LM in boot mode no problem.
ECUHELP KT200 R /W GPEC3
Connect the pinout below with multifunction cable.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Tool Password
→ PASSWORD BFT
→ Click on “Find Password” and follow the
software messages. If the password was found with this system, go
directly to the boot step to read and write the
control unit.
Otherwise, change CAN line position and try again
with PASSWORD BFT: Now that the password has been found it’s possible
to read and write the control unit.
READ AND WRITE ECU
Remove the white and violet wires from the pinout and replace the red wire of pin 50 with a green wire of the igniction. Solder the gray wire to the indicated point: Use the driver: → TOOLS BOOT MODE → INFINEON TRICORE Boot → SAK TC1793
ECUHELP KT200 R /W GPEC4LM
Connect with the multifunction cable the CNF1 signal on
the pcb.
Use the driver:
→ TOOLS BOOT MODE
→ MOTOROLA FREESCALE BAM
→ FCA CONTINENTAL GPEC4LM
ECUHELP KT200 Tech support: whatsapp: http://wa.me/8618205996549
And online support: https://www.ecuhelpshop.com/